#include <WiFi.h>
#include <WiFiClient.h>
#include <WiFiAP.h>



// Set these to your desired credentials.
const char *ssid = "sabro_aircon";
const char *password = "timi373timi";
uint16_t count = 0;



WiFiServer server(80);


void setup() {
  pinMode(LED_BUILTIN, OUTPUT);

  Serial.begin(115200);
  Serial.println();
  Serial.println("Configuring access point...");

  // You can remove the password parameter if you want the AP to be open.
  WiFi.softAP(ssid, password);
  IPAddress myIP = WiFi.softAPIP();
  Serial.print("AP IP address: ");
  Serial.println(myIP);
  server.begin();
 

  Serial.println("Server started");
}

void loop() 

{
 
  
  WiFiClient client = server.available();   // listen for incoming clients
 
if (client) {                             // if you get a client,
    Serial.println("New Client.");  
                        // if you get a client,
    Serial.println("serial data avaliable");           // print a message out the serial port
   
client.print(count);
        if (client.available()) {             // if there's bytes to read from the client,
      String my= client.readString();             // read a byte, then
        Serial.println(my);                    // print it out the serial monitor
        
       // client.print(count);
      }

        
      }
 client.stop();
 Serial.println("Client Disconnected.");
   
  

delay(500);
if (!client) {
    Serial.println("no_client");
}
count=count+1;
Serial.print("couter is =");
Serial.println(count);
}