Id say upgrades are optional, Im enjoying mine as it is. I think upgrades are for uber geeks
-
Welcome to B4X forum!
B4X is a set of simple and powerful cross platform RAD tools:
- B4A (free) - Android development
- B4J (free) - Desktop and Server development
- B4i - iOS development
- B4R (free) - Arduino, ESP8266 and ESP32 development
My first 3D print, after assembly, with Anet A6
- Thread starter Deleted member 103
- Start date
- Similar Threads Similar Threads
In my experience, both machines (A8, what i have and A6) needs some upgrades, that can be easily done by the proper machine, and you can use the construction of these upgrades as a learning process.
Also, I have no doubt that for the most of the "diy" purposes is enough with any of them. With a simple knowledge you can achieve almost professional results.
Regards.
D
Deleted member 103
Guest
and this is my first almost finished product.
D
Deleted member 103
Guest
New Video
ABS???
D
Deleted member 103
Guest
No, for now only PLA.
I could not tame ABS yet. I used PETG with a very good results of strength and impact resistance...No, for now only PLA.
D
Deleted member 103
Guest
D
Deleted member 103
Guest
WOW! It is cheaper than at Aliexpress.
How much they charge to your country?WOW! It is cheaper than at Aliexpress.
They are from Spain... they delivers for free if you buy more than 20€.
I also found some PETG spools on Amazon at good price, I have the Premium and it worths
D
Deleted member 103
Guest
235 nozzle, 50 heatbed the first 20 layers, then shutdown
D
Deleted member 103
Guest
I use Cura 14.07, where can I set "heatbed the first 20 layers, then shutdown"?
There is no option on Cura to set it, I used Simplify and also Slic3r...
Dont worry about the heatbed, in theory, is not needed for PETG, so you can let it turned on.
Can you upload any pic about the results you are getting? Perhaps its not a temperature problem.
Regards.
Dont worry about the heatbed, in theory, is not needed for PETG, so you can let it turned on.
Can you upload any pic about the results you are getting? Perhaps its not a temperature problem.
Regards.
D
Deleted member 103
Guest
Here is a photo.
So, either the parameters do not match or my PETG is bad quality.
Try to decrease the speed when you make the pins.
D
Deleted member 103
Guest
This is not possible, the pins are not created separately.