Check Bluetooth external Batterie using basic4ppc

Discussion in 'Questions (Windows Mobile)' started by wm.chatman, Apr 21, 2009.

  1. wm.chatman

    wm.chatman Well-Known Member Licensed User

    :)Hello folks

    Sorry about the Header.

    Just another Question, :sign0137:if I may.
    is it possible to Check GPS Receivers external Batterie (ext module) using Bluetooth using basic4ppc?
    I am thinking / NO


    best Regards to all,
    WmC

    PC: Laptop CoreDUo, Windows XP SP2 E
    PPC: MDA Pro/WM5
    OS: 5.1.195
    Prozessor: PXA-520 Mhz
    Display: 480x640 TFT
    Periphery: GPS Receiver (ext module)
    Bayern/Germany
     
    Last edited: Apr 21, 2009
  2. Zenerdiode

    Zenerdiode Active Member Licensed User

    This is going to be very manufacturer-specific. There may be a request you can send to the module over Bluetooth that it will respond with battery strength. If so, the Serial library is all you need. I think you'll need to consult some manufacturers documents to see if it is supported.
     
  3. wm.chatman

    wm.chatman Well-Known Member Licensed User

    :)Hello

    Was not able to find out much.

    Main Interfaces
    Connection: Communication with host platform via Bluetooth Serial Port Profile
    Protocol Messages: NMEA 0183 output protocol
    Baud Rate: 38400 bps
    Data Bit: 8
    Stop Bit: 1
    Output Format: GGA (1 sec), GSA (1 sec), GSV (5 sec), RMC (1 sec), VTG (1 sec)

    Battery Source: rechargeable and removable Lithium Polymer battery with 5vDC input charging circuit (1200 mA)

    best regards,
    WmC
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice