IDE and Form Designer add events

Discussion in 'Beta Versions' started by klaus, Apr 24, 2009.

  1. klaus

    klaus Expert Licensed User

    In the new IDE Form designer when adding an event to a Control the Form Designer is systematically closed.
    I don't find this behaviour very usefull. If I add some buttons on a form I would prefer adding directly the event routine frames like Sub Routine_Click / End Sub for all buttons in the Form Designer and then closing it normally to go back to the editor to fill in the routines.
    In the old Designer there was a MessageBox asking if we would leave. Clicking on Abort the Form Designer didn't close.

    Best regards.
     
  2. agraham

    agraham Expert Licensed User

    I agree!
     
  3. Erel

    Erel Administrator Staff Member Licensed User

    I will explain. This specific behavior wasn't change. The "save your changes" mechanism was improved and this question now only appears if there was a real change.

    However I also agree that it is annoying and will change it to just show a message box about the new sub and continue.
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice