B4R Question Seeeduino XIAO runs fine in IDE only.

["Marty"]

My experience with this new Arduino compatible board:

Test Date: April 24, 2021
Arduino IDE: 1.8.13
B4R IDE: 3.71
Micro Board: Seeeduino XIAO with 256KB Flash and 32KB SRAM

The XIAO is $8 USD and about 10 times? more powerful than UNO.

Situation:
Arduino IDE runs the XIAO board fine. (e.g Blink program)
B4R IDE runs the XIAO board fine. (e.g B4R Blink program)

When using Arduino IDE:
If XIAO is powered up without being attached to IDE then XIAO will run its program.


Problem:
When using B4R IDE:
If XIAO is powered up without being attached to IDE then XIAO will not run its program.

Possible Cause:
It seems that B4R causes something to be programmed into the XIAO
that makes running the program dependant on the live B4R environment.

Summary:
When using B4R IDE, the programmed XIAO will not run
on it's own, (without being attached to the B4R IDE and "Connected").

I hope someone can comment, as XIAO is too exciting to ignore.

 

[Erel]

Try to comment the Serial1.Initialize line and any call to Log.

 

["Marty"]

Thank you Erel.
Your suggestion is a success.

Comment out just the calls to Log lines: No effect.
Comment out just Serial1.Initialize line: Problem solved.