Beta V5.0 beta #2 - no stop at breaking points at first

Discussion in 'Android Questions' started by leitor79, May 30, 2015.

  1. leitor79

    leitor79 Active Member Licensed User


    I've run the project with some break points and the execution didn't stop at them (legacy mode was set by default). I've switch to rapid mode and it fixed. Switched back to legacy and "fixation" mantained.
  2. Erel

    Erel Administrator Staff Member Licensed User

    I'm unable to reproduce it. Does it happen again if you restart the IDE?

    Note that you should use the rapid debugger (which is set by default, the IDE loaded your last settings from the old IDE) unless you encounter an issue with it.
    Peter Simpson likes this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice