Hi Everyone, I am working on a project where I have a raspberry pi 4B where I have a b4j app running which communicates with a 32 channel Analog to Digital Converter we designed and built at work, the communication is via I2C protocol, this part works very well as far as I have been able to...
Hi all, I am working on a project for work, basically I am attaching a DAQ (Data Acquisition System) we designed with 4 ADCs that communicate with raspberry pi over I2C communication protocol. This all seems to work fine so far, I am able to communicate with each of the ADCs and collect data...
A doorbell for Arduino Uno or Nano interfacing EEPROM with I2C. The EEPROM 24C512 is 512Kbits and it can store up to 3 seconds wave file of 22.050KHz, 8 bits, mono.
The Arduino reads the ROM bytes in a sequential read mode and stream each byte to the PWM generator at a rate of 22 KHz. The I2C...
Hello,
I'm trying to communicate a raspberry pi 3 model B with ADS1115 through i2c communication,
but it is not working.
When I run an adafruit example in python, its works
perfectly.
Using and arduino Mega i can read what python example sends to ADS1115 and I tried to send the same commands...
Hello everyone,
Here an example for using the MCP9808 sensor on a raspberry pi.
This is only a code snippet, as it only read's the temperature.
Not all the registers are implemented.
Negative values aren't yet tested.
This is a console application.
Kind regards,
Tim.
*IMPORTANT UPDATE*
The...