Hello again,
In my current script, I've tryed to do a Loop routine, similar to VB, but with the B4A rules.
The routine in VB is something like this:
Do
(...procedures1...)
If nt > sd Then
Exit Loop ' ---------- EXIT
End If
(...procedures2...)
Loop
I've tryed:
Do Until (nt > sd)
(...procedures1...)
(...procedures2...)
Loop
But, from the several results I get, the last one is always wrong - so I suspect that this Loop in B4A is not working properly mainly because it's running
procedures2 in sequence of
procedures1.
Any tips or workarounds on this issue?
Kind regards,
Kepler