B4J Question [ABMaterial]: How to decrease the height of components in the same RC?

[Mashiane]

Hi there

I am adding components, ABMInput, ABMCombo and ABMCheckBox in the same RC, e.g. 4,1 one after another.

How can I decrease the height of each component being added to a mininum, lets say 40px for example?

Thanks a lot!

 

[alwaysbusy]

You can't (and you never will). You can set a cell height for example, but not on individual components.

On a side not: it is bad practice what you do. You should design a proper grid, and assign the components accordingly. Use the GridBuilder to design the grid.

 

[Mashiane]

You can't (and you never will). You can set a cell height for example, but not on individual components.

On a side not: it is bad practice what you do. You should design a proper grid, and assign the components accordingly. Use the GridBuilder to design the grid.

Thanks for the response. I note your recommendations, the thing is the components I'm adding are not fixed, could be 5, 10 or 15 components at one time, one after another. It's not a train smash if it cant be done though I had hoped it was possible.