I am unable to connect an ESP8266 MCU on arduino UNO with rSoftwareSerial.
It seems that the rSoftwareSeria library does not work in ESP.
Everything works fine on Arduino UNO (Pin 10 and 11). In ESP8266 the only pins that
I can use are RX and TX (pins 1 and 3) but I need to use pins 13 and 15. Does anyone have any ideas?
I am unable to connect an ESP8266 MCU on arduino UNO with rSoftwareSerial.
It seems that the rSoftwareSeria library does not work in ESP.
Everything works fine on Arduino UNO (Pin 10 and 11). In ESP8266 the only pins that
I can use are RX and TX (pins 1 and 3) but I need to use pins 13 and 15. Does anyone have any ideas?
Does someone know dataformat of softserial and can I change it (Startbit, stopbit) in c-source? What I need is "start bit: 1bit; data bit: 8 bits; parity bit: none; stop bit: 1 bit. " ... it does not work in my communication-setting with esp and WT2000 chip and I dont know, if data format is...
Does someone know dataformat of softserial and can I change it (Startbit, stopbit) in c-source? What I need is "start bit: 1bit; data bit: 8 bits; parity bit: none; stop bit: 1 bit. " ... it does not work in my communication-setting with esp and WT2000 chip and I dont know, if data format is...
... check, if pins you use are able for pwm... .I use D1 and D2 at D1 mini, but mcu may b different. Probably, you need d1 As D1Pins library for mcu too (Private d1 As D1Pins). So you dont initialize Softserial1.Initialize(57600, 1,2) but Softserial1.Initialize(57600, d1.d1,d1.d2)
... check, if pins you use are able for pwm... .I use D1 and D2 at D1 mini, but mcu may b different. Probably, you need d1 As D1Pins library for mcu too (Private d1 As D1Pins). So you dont initialize Softserial1.Initialize(57600, 1,2) but Softserial1.Initialize(57600, d1.d1,d1.d2)