iOS Question B4Bridge and connection problem

Filippo

Expert
Licensed User
Longtime User
Hi,

since a few days I use a new PC with Windows 11 and have problems with B4Bridge.
The IDE recognizes the connected devices, but it always comes this message.



Notes & Tips

-
By default ports numbers 51041 (http) and 51042 (https) are used.
- The firewall should be either disabled or allow incoming connections on these two ports.
I have also already set this, unfortunately also without success.
Is there still ertwas what you should pay attention?

The compilation in release mode works well, only the debugging does not work.
 

Filippo

Expert
Licensed User
Longtime User
Everything works again as it should.
Why it did not work? I don't know, because I didn't make any changes to the system.
 
Upvote 0
Cookies are required to use this site. You must accept them to continue using the site. Learn more…