Check Bluetooth external Batterie using basic4ppc

Hello folks

Sorry about the Header.

Just another Question, :sign0137:if I may.
is it possible to Check GPS Receivers external Batterie (ext module) using Bluetooth using basic4ppc?
I am thinking / NO


best Regards to all,
WmC

PC: Laptop CoreDUo, Windows XP SP2 E
PPC: MDA Pro/WM5
OS: 5.1.195
Prozessor: PXA-520 Mhz
Display: 480x640 TFT
Periphery: GPS Receiver (ext module)
Bayern/Germany

This is going to be very manufacturer-specific. There may be a request you can send to the module over Bluetooth that it will respond with battery strength. If so, the Serial library is all you need. I think you'll need to consult some manufacturers documents to see if it is supported.

Hello

Was not able to find out much.

Main Interfaces
Connection: Communication with host platform via Bluetooth Serial Port Profile
Protocol Messages: NMEA 0183 output protocol
Baud Rate: 38400 bps
Data Bit: 8
Stop Bit: 1
Output Format: GGA (1 sec), GSA (1 sec), GSV (5 sec), RMC (1 sec), VTG (1 sec)

Battery Source: rechargeable and removable Lithium Polymer battery with 5vDC input charging circuit (1200 mA)

best regards,
WmC