B4R Question Geekright stop program execution

Discussion in 'B4R Questions' started by hatzisn, Jul 15, 2019.

  1. hatzisn

    hatzisn Active Member Licensed User

    Hi everybody,

    I just made my first successful experiment with B4R and Geekright atmega2560 board. Well, half successful since I do not know how to stop the program from running. :confused: I tried pressing reset but it restarts. I also tried removing the USB but when I put it back in it restarts again.

    Any suggestions?

    Thanks
     
    Last edited: Jul 15, 2019
  2. janderkan

    janderkan Active Member Licensed User

    This is what it should do :)
     
  3. hatzisn

    hatzisn Active Member Licensed User

  4. tigrot

    tigrot Well-Known Member Licensed User

    A micro is always running, if you don't toggle RST pin. If you take away USB you switch off power as well. So when you connect, the sequence POWER/RST restarts micro's program execution.
    Ciao
    Mauro
     
  5. hatzisn

    hatzisn Active Member Licensed User

    Grazie mille Mauro. E stata molto chiara la tua risposta.
     
    tigrot likes this.
  6. tigrot

    tigrot Well-Known Member Licensed User

    Italiano perfetto! Complimenti e grazie!
     
    hatzisn likes this.
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice