If I download a sbp file from my desktop to my Diamond I find that the width of a 200 wide by 200 high Image control magically increases to 201! This happens without entering the Designer
If I start a new project on the device, add a Form, add an Image and set it to 200 x 200 I find on exiting the Designer that the width has increased to 201. In fact this happens for any value of width, it ends up with 1 added to it! As I enter exit and re-enter the Designer the width keeps getting incremented without my doing anything except look at the Image properties as long as I say yes to save the (non) changes! Height seems unaffected. This doesn't seem to happen on my non-VGA Axim X30.
I didn't have to investigate far to find this as my demo app crashed on the device but not on the desktop so I sort of "fell over" it - or rather my code did!
If I download a sbp file from my desktop to my Diamond I find that the width of a 200 wide by 200 high Image control magically increases to 201! This happens without entering the Designer
If I start a new project on the device, add a Form, add an Image and set it to 200 x 200 I find on exiting the Designer that the width has increased to 201. In fact this happens for any value of width, it ends up with 1 added to it! As I enter exit and re-enter the Designer the width keeps getting incremented without my doing anything except look at the Image properties as long as I say yes to save the (non) changes! Height seems unaffected. This doesn't seem to happen on my non-VGA Axim X30.
This behavior also exists if we create an image control and "duplicate" the control.
The resultant control, the duplicate, as its width increased by 1.
I noticed this when trying to create my simplistic Auto-Adjust module, a few weeks ago..., but thought it was my device going nuts...So I re-flashed it..but never tryied it again since..