Sub GPS_GPSDecoded
ListBox1.Clear
ListBox1.add("Status: "& GPS.status)
ListBox1.Add("Number Of Satellites: " & GPS.NumberOfSatellites)
ListBox1.Add("Time: " & GPS.UTCTime)
ListBox1.add("Lat: " & GPS.latitude)
ListBox1.add("Lon: " & GPS.longitude)
ListBox1.add("DecLat: "& GPS.DecimalLatitude)
ListBox1.Add("DecLon: " & GPS.DecimalLongitude)
ListBox1.add("Speed: "& GPS.SpeedOverGround * 1.852) 'Converts the speed to km/h.
ListBox1.Add("Course: " & GPS.CourseOverGround)
ListBox1.Add("Altitude: " & GPS.Altitude)
utm() = converter.WGS84LatLonToUTM(GPS.DecimalLatitude,GPS.DecimalLongitude) 'Converts the Lat/Lon coordinates to UTM.
ListBox1.Add("XZone: " & utm(0))
ListBox1.Add("X: " & utm(1))
ListBox1.Add("YZone: " & Chr(utm(2)))
ListBox1.Add("Y: " & utm(3))
End Sub
Debugging on the Ipaq is a little bit difficult for me and I cannot get the CF Card running on the PC. I'll try to figure out how to setup Basic4ppc on the device with the right file locations as I remember the source should be in specific libraries to access them.