Sub Joystick1_onMove (Angle As Double, Pow As Double)
Cap = Joystick1.AngleDegrees
Log("ANGLE: " & Angle)
Log("Angle in degrees: " & Cap)
Log("Power: "& Pow)
If Pow < 25 Then 'dead zone to prevent unintended movements
'Angle cutting (0 to + or - 180°) to define the direction to take
'If Cap > 25 And Cap < 90 Then
'End If
Else if Cap > 45 And Cap < 135 Then
Log("Angle in degrees: " & Cap)
If Pow > 40 And Pow < 80 Then Order = 10 : Direction = "Forward"
If Pow > 80 Then Order = 11 : Direction = "Fast Forward"
Log("Direction: " & Direction)
Else if Cap < -45 And Cap > -135 Then
Log("Angle in degrees: " & Cap)
If Pow > 40 And Pow < 80 Then Order = 12 : Direction ="Backward"
If Pow > 80 Then Order = 13 : Direction = "Fast Reverse"
Log("Direction: " & Direction)
Else if Cap < 37 And Cap > -45 Then
Log("Angle in degrees: " & Cap)
If Pow > 40 And Pow <80 Then Direction = "Turn right" : Order = 4
If Pow > 80 Then Order = 5 : Direction ="turn sharply to the right"
Log("Direction: " & Direction)
Else if Cap > 135 And Cap > -135 Then
Log("Angle in degrees: " & Cap)
If Pow > 40 And Pow <80 Then Direction = "Turn left" : Order = 6
If Pow > 80 Then Order = 7 : Direction ="turn sharply to the left"
Log("Direction: " & Direction)
else if Pow < 40 Then
Direction = "STOP" : Order = 0
Log("Direction: " & Direction)
End If
' FILTER: AVOID DUPLICATES : The byte is sent ONLY if the direction has changed.
If Order <> LastOrderSent Then
LastOrderSent = Order
B4XPages.MainPage.BTA.Write(Array As Byte(Order))
End If
End Sub