Apr 12, 2016 Replies: 4 Hi, based on previous Analog Read Example, Analog Read Example using Ethernet, Analog Read Example using MQTT extended the solution by displaying the temperature (in C and F) from the TMP36 sensor on the Arduino LCD Shield. Full project (with comments) attached. Attachments B4RHowToTMP36LCD.zip B4RHowToTMP36LCD.zip 1.8 KB · Views: 1,058 Click to expand...
Hi, based on previous Analog Read Example, Analog Read Example using Ethernet, Analog Read Example using MQTT extended the solution by displaying the temperature (in C and F) from the TMP36 sensor on the Arduino LCD Shield. Full project (with comments) attached.
tufanv Expert Licensed User Longtime User Apr 13, 2016 #2 the holes of the lcd panel is a bit large for my cables. Do i have to use a solder ?
rwblinn Well-Known Member Licensed User Longtime User Apr 13, 2016 #3 For the tests I did, just pulled them in without soldering - worked - see the pic.
tufanv Expert Licensed User Longtime User Apr 19, 2016 #4 I am using a lm35. It gives me negative results on the logs. There must be a caluclation change for lm35 ?
I am using a lm35. It gives me negative results on the logs. There must be a caluclation change for lm35 ?
rwblinn Well-Known Member Licensed User Longtime User Apr 19, 2016 #5 Hi, check out here. Code: tempC = reading / 9.31
