Following these instructions you have access to the 3 hardware serials on an ESP32.
Serial0 is connected to the USB interface.
The default pins are
Serial0 - RX: GPIO3 , TX: GPIO1
Serial1 - RX: GPIO9 , TX: GPIO10
Serial2 - RX: GPIO16 , TX: GPIO17
On a TTGO Lora board the GPIO 9,10,16,17 are not available,
but you can use almost any other pin with this code.
Serial0 is connected to the USB interface.
The default pins are
Serial0 - RX: GPIO3 , TX: GPIO1
Serial1 - RX: GPIO9 , TX: GPIO10
Serial2 - RX: GPIO16 , TX: GPIO17
On a TTGO Lora board the GPIO 9,10,16,17 are not available,
but you can use almost any other pin with this code.
B4X:
'RX=2, TX=4
#if C
void SerialNative1(B4R::Object* unused){
::Serial1.begin(115200, SERIAL_8N1, 2, 4);
b4r_main::_serialnative1->wrappedStream = &::Serial1;
}
#End If
