Hardware-library and vibrate ??

[moster67]

Hi, I knew about a small little library which permits you to enable and disable the vibrate-mode on the device (useful for emphasizing that a button has been pressed) and I know where to find it.

However, from this post, http://www.b4x.com/forum/announcements/906-hardware-library-updated-3-10-a.html#post4579, Erel announced it was included in the Hardware-library using VibrateStart / VibrateStop.

I must be blind but I can't find them included in the Hardware-library. Have they by any chance been removed in later versions of the library? Or have they been included in some other official library?

Thanks for your help.

 

[Erel]

It was eventually removed from the hardware library due to some technical problems. However as far as I know this small library should work properly: http://www.b4x.com/forum/announcements/906-hardware-library-updated-3-10-a.html#post4619

 

[moster67]

Yes, I know. That was the library related to my question of the other day when I asked you about merging a library into an executable. Everything sorted out.

It was eventually removed from the hardware library due to some technical problems. However as far as I know this small library should work properly: http://www.b4x.com/forum/announcements/906-hardware-library-updated-3-10-a.html#post4619