iOS Question How can I install b4i-bridge without using safari

davepamn

Active Member
Licensed User
I want to install b4i-Bridge using email. I need to know what file to install from the application server.
 

davepamn

Active Member
Licensed User
should I subscribe the annual build server subscription, if the itunes install fails
 

davepamn

Active Member
Licensed User
I was able to install b4i-bridge using iTunes
1. Add App (b4i-bridge.ipa)
2. iTunes App -> B4iBridge (Install)
3. Apply (syncs)
 

davepamn

Active Member
Licensed User
I get a message from b4i that says, "Make sure that B4i-Bridge is started at xx.xx.103.6)
However the ip address for my application server is xx.xx.102.32

where do I change the xx.xx.103.6 address?

I was able to use iTunes to install the release app on the device. I would like to be able to use safari.
 
Last edited:

Erel

Administrator
Staff member
Licensed User
where is the app name "B4i Example" defined in b4i?
Please start a new thread for this question.

where do I change the xx.xx.103.6 address?
There are two different ip address. The device ip and the server ip.

You cannot change the device ip address. You need to set this ip in the IDE under Tools - Device IP address.
 

davepamn

Active Member
Licensed User
I set my device IP Address to 10.xx.103.6
I can create a release ipa and install it on the iPad using iTunes
I want to be able to debug using bridge.
 
Last edited:

davepamn

Active Member
Licensed User
Yes
I push the release version using iTunes to the iPad.
08:36:55| Compilation time: 1996, b4i_default, queue: 0, success: true

I believe the uuid is correct because the app installs
 

davepamn

Active Member
Licensed User
I installed b4i Bridge on the iPad using iTunes

I can see designer layout for my app in bridge when I open it

I run b4i Debug for the app and the iPad device returns a message "Can not connect to 10.21.102.32" which is the mac
 
Top