B4R Question How to interrupt the Arduino controller

Discussion in 'B4R Questions' started by Beja, Apr 8, 2019.

  1. Beja

    Beja Expert Licensed User

    Hi all,

    I am working on a project to open or close a water pump, according to the water level in the tank.
    I have the sensors that will send analog signals that correspond to the water level.
    Is there any way other than polling the analog signal?
    Or there's an interrupt pin that I am not aware about?

    Thanks in advance. B
     
  2. Cableguy

    Cableguy Expert Licensed User

    B4r does not use interrupts...

    You can try to add an interrupt code block in C and have it call a B4R sub... Untested
     
  3. thetahsk

    thetahsk Active Member Licensed User

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice