My first 3D print, after assembly, with Anet A6

D

Deleted member 103

Guest
Hi guys,
and what is your opinion? Does not it look nice?
Both 3d printers are running well now, I could almost work as a service provider.

 

JakeBullet70

Well-Known Member
Licensed User
Longtime User
Well my Tevo up and died. Will not complain as I got a good 2 years out of it and an education. I am at that point that I really do not want to rebuild it and I am looking for something nicer. I keep looking at @Filippo Anycubic and have discovered that here in Ukraine we have an Anycubic authorized dealer!

So... The question now is a I3 Mega or a 4max.
 

JakeBullet70

Well-Known Member
Licensed User
Longtime User
And... Dead Y axis... Motor is fine looks like the controller board. Contacting support.
 

Attachments

  • IMG_20190505_213419.jpg
    206.9 KB · Views: 156

JakeBullet70

Well-Known Member
Licensed User
Longtime User
Up and running!
Contacted support as I bought the printer local and not through China and they replaced the whole board assembly with a new power supply. I have had it for a week but have been too busy until today to install it. @Filippo you were right, the anycubic ultrabase is great!!! Leveled the bed and printed fine the first time!
 
Last edited:
D

Deleted member 103

Guest
@Filippo you were right, the anycubic ultrabase is great!!!
Click to expand...
and if you use "Simplify3D" as software, then everything is even better.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…