My first 3D print, after assembly, with Anet A6

D

Deleted member 103

Guest
Hi guys,
and what is your opinion? Does not it look nice?
Both 3d printers are running well now, I could almost work as a service provider.

upload_2019-4-12_20-39-55.png
 

Cableguy

Expert
Licensed User
Longtime User
Hi guys,
and what is your opinion? Does not it look nice?
Both 3d printers are running well now, I could almost work as a service provider.

View attachment 79300

Why not? I would be one of your potential customers, since I do not yet own one!
 

JakeBullet70

Well-Known Member
Licensed User
Longtime User
Well my Tevo up and died. Will not complain as I got a good 2 years out of it and an education. I am at that point that I really do not want to rebuild it and I am looking for something nicer. I keep looking at @Filippo Anycubic and have discovered that here in Ukraine we have an Anycubic authorized dealer!

So... The question now is a I3 Mega or a 4max.
 

JakeBullet70

Well-Known Member
Licensed User
Longtime User
And... Dead Y axis... Motor is fine looks like the controller board. Contacting support. :(
 

Attachments

  • IMG_20190505_213419.jpg
    IMG_20190505_213419.jpg
    206.9 KB · Views: 182

JakeBullet70

Well-Known Member
Licensed User
Longtime User
Up and running!
Contacted support as I bought the printer local and not through China and they replaced the whole board assembly with a new power supply. I have had it for a week but have been too busy until today to install it. @Filippo you were right, the anycubic ultrabase is great!!! Leveled the bed and printed fine the first time!
 
Last edited:
D

Deleted member 103

Guest
@Filippo you were right, the anycubic ultrabase is great!!!
and if you use "Simplify3D" as software, then everything is even better. ;)
 
Top