Id say upgrades are optional, Im enjoying mine as it is. I think upgrades are for uber geeksSo what I am getting from this thread is the Anet A6 is not a bad machine but does need upgrades?
Id say upgrades are optional, Im enjoying mine as it is. I think upgrades are for uber geeksSo what I am getting from this thread is the Anet A6 is not a bad machine but does need upgrades?
In my experience, both machines (A8, what i have and A6) needs some upgrades, that can be easily done by the proper machine, and you can use the construction of these upgrades as a learning process.So what I am getting from this thread is the Anet A6 is not a bad machine but does need upgrades?
ABS???
No, for now only PLA.ABS???
I could not tame ABS yet. I used PETG with a very good results of strength and impact resistance...No, for now only PLA.
PETG ?I could not tame ABS yet. I used PETG with a very good results of strength and impact resistance...
Yes, I bought it on www.cartucho.esPETG ?
Have not known until today.
Where do you buy it? Do you have a link?
WOW! It is cheaper than at Aliexpress.Yes, I bought it on www.cartucho.es
For sure there must be a shop on your country that sells it.
How much they charge to your country?WOW! It is cheaper than at Aliexpress.
235 nozzle, 50 heatbed the first 20 layers, then shutdown
Here is a photo.
So, either the parameters do not match or my PETG is bad quality.
This is not possible, the pins are not created separately.Try to decrease the speed when you make the pins.