B4R Question Restart the GSM Module 800L

Discussion in 'B4R Questions' started by AndroidMadhu, Jun 12, 2019.

  1. AndroidMadhu

    AndroidMadhu Active Member Licensed User

    Hello,
    I have the code which is running fine and data is coming as usual using GSM.
    If I connect the GSM from B4R, then it is running... but if I power off both GSm and Arduino and then again power on the GSM and Arduino, the data is not fetching.
    Again I have to re-open B4R and then press connect.Then the GSM module is running.

    Is there is any change I required to incorporate to automatic restarting of GSM module.
     
  2. janderkan

    janderkan Active Member Licensed User

    A schematic on your connections and a bit of code would do it a lot easier to help.
     
  3. AndroidMadhu

    AndroidMadhu Active Member Licensed User

    @janderkan
    Could you please put some light on this please????
    Also what will b the schematic design? Is it the POWERKY will be connected to the ground???
    Please suggest...
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice