B4R Question Arduino 101 BT not discovered.

Beja

Expert
Licensed User
Longtime User
Hi all,
I am trying the 101 examples and both, the Android app and the Arduino app are installed successful.
After running the Android app, it stuck in the discovery process for a very long time.
Then I went to settings in the Android phone to try to pair from there.. this is the message..
Any clue appreciated.

101_BT.png
 

Beja

Expert
Licensed User
Longtime User
Hi Erel,
No logs in Android side.. when run it says "Trying to connect"

The B4R app also compiles fine, and the log is "Sending 'open' command to B4J serial connector."

I hope it's not from my phones.. I am using LG G Stylo, and Samsung DUOS
 
Upvote 0

Beja

Expert
Licensed User
Longtime User
Just used "BLE Checker" from Donly Tools.. both mobiles support BLE
 
Upvote 0

Cableguy

Expert
Licensed User
Longtime User
Just used "BLE Checker" from Donly Tools.. both mobiles support BLE
Hummm maybe a too obvious question but, what board are you running it on?
Arduino 101 is a "special" version of the Uno with built in Bluetooth...
 
Upvote 0

Cableguy

Expert
Licensed User
Longtime User
I saw your posts a few minutes after I posted the previous, so I meant no disrespect to you @Beja, only to mention that sometimes we bypass the obvious...
 
Upvote 0

Beja

Expert
Licensed User
Longtime User
I never thought like that.. I just replied to you briefly because was going out and was late.. that I even forgot to tell you Thanks for the reply. Thank you
 
Upvote 0
Top