Issue on device IDE

[corwin42]

In previous versions of the device DIE if you typed a . (dot) after an object name or control name then a list popped up with all members and properties. This does not work anymore.

Greetings,
Markus

 

[Erel]

I can't reproduce this problem.
Can you upload a small program in which you don't get this list?

 

[agraham]

It's not the program. In the new device VGA IDE I get the popup help. If I load the same program into the QVGA IDE I don't get the popup there either.

 

[Erel]

Do you never see the list? Even if you create a new program with one form and write Form1. ?

 

[agraham]

Do you never see the list? Even if you create a new program with one form and write Form1. ?

Odd! You are right, I do get it then.

EDIT :- Sorry, looks like a problem with Autocomplete on my Resco keyboard was confusing me (easily done nowadays )

 

[corwin42]

Do you never see the list? Even if you create a new program with one form and write Form1. ?

Just tried it. I never get the popup list. Even if I create a new program.

I have an ASUS A696 QVGA Device with WM6 Classic if this is important.

 

[corwin42]

Strange. I didn't change anything but now it works without a problem. I have done a soft reset of my device. Perhaps this was the solution.

Thanks,
Markus