Bug? Page up on B4A IDE

[Luciano Anselmetti]

Hello everybody,
I report here a behavior of the IDE, I hope it is the right section of the forum.

I have installed the latest version (11.0) of B4A IDE, and have noticed that the cursor movement is correct when I press "page down", moving the cursor down about the amount of lines displayed in the editor window. When I go back with "page up", however, the cursor does not go back the same number of lines of page down, but initially only a few lines, and then increases with more key presses.
I don't know if it is a problem only on my pc, but trying the same on B4J IDE instead, it works fine.
I don't remember if the previous versions had the same behavior, I never noticed ...

Thanks for the IIF !!

 

[Luciano Anselmetti]

Update: the cursor move back in strange mode only if it before has reached the end of code window

 

[Luciano Anselmetti]

Update: the cursor move back in strange mode only if it before has reached the end of code window

More update:
I understood! the cursor move up for the lines displayed. When I move the cursor at bottom, I see only last rows on screen; if I return back, the cursor jumps about the lines showed. Unlike I wrote before, the behavior is the same on B4J, too.

I think this is not a problem, please ignore my report ...

Bye