Android Question Visual designer won't match tablet size

[saunwin]

Hi Guys,

So I lay out my screen/view in visual designer (connected to my tablet via bridge) all looks good (abstract designer matching connected device) until I compile - then half the "views" are hanging off the screen/missing. I'm sure this didn't happen before (old version). TIA.

 

[stevel05]

Have you set the anchors for each view?

 

[saunwin]

No, but surely it's a scaling thing - everything on the tablet (after compiling and running) is too big

 

[stevel05]

It will use the variant size from the designer. Setting the anchors is the way to go.

 

[saunwin]

Thanks Steve.
Just to finish this thread
The anchors were set.
I hadn't added my tablet screen size to the variants panel and it was using 320x480 (the only variant listed and I suspect the default/only one listing in a fresh install).
Cheers