Android Question [Closed] BridgeCLI (No Results)

[Jorge M A]

Hello Everyone,

I have tried to use the BridgeCLI command line as indicated in this link, to list the connected devices. However, it does not show any results.
If I add the -verbose option to the command, I get a series of messages that I am not able to interpret. (Annex messages log)

Could someone tell me what I'm missing?

Testing in Windows 10 Pro x64
BXA 7.8
BXA-Bridge 2.50
Two physical devices via wi-fi, which show their own IP, and a VMWare VM.
(Kapersky AV if matters)

Thank you!

 

[Erel]

There is no -verbose option. You are seeing the JVM irrelevant logs.

What is the output of:

java -jar BridgeCLI.jar -Discover

This will only work if your network doesn't block the broadcasted UDP packets.

If not then you can explicitly set the ip address.

 

[Jorge M A]

Thanks as always @Erel,

What is the output

Nothing at all. (only blinking cursor again).

This will only work if your network doesn't block the broadcasted UDP packets.

I'll go to check this.

 

[Jorge M A]

Hi @Erel, this is what I found from online port scanner, but I don't know if is enough.
Is there any specific port for BridgeCLI to be opened? (BXA-Bridge works fine in every case)

Starting Nmap 7.40 ( https://nmap.org ) at 2018-01-12 16:24 UTC
Nmap scan report for 189.236.xx.xxx
Host is up.
PORT     STATE         SERVICE
53/udp   open|filtered domain
123/udp  open|filtered ntp
161/udp  open|filtered snmp
1900/udp open|filtered upnp
5353/udp open|filtered zeroconf

Nmap done: 1 IP address (1 host up) scanned in 2.07 seconds

 

[Erel]

Does it work when you explicitly set the ip address?

 

[Jorge M A]

Yes @Erel! this way is working fine!
This is more than enough for what I need.
Really thank you very much!