Android Question ESP-01 with Relay

yaqoob

Active Member
Licensed User
Longtime User
Hi,
I am using ESP-01 with Relay. My application works perfectly first time and immediately after uploading it to the ESP01S and debugging it. After disconnecting and rebooting, it does not work. It looks like lost or does not know from where to start. The same application using ESP8266 works fine even after booting many times. Any ideas or suggestions?

Thank you.

 

Cableguy

Expert
Licensed User
Longtime User
If I remember correctly, boards like the esp01 need to be set to "firmware programming mode" by hardware... So my question is, are you setting this mode off after flashing?
 
Upvote 0
Top