iOS Question Install/Debug via Cable in a MAC LOCAL BUIDER

[Alberto Iglesias]

My iPhone is connected in a Mac with XCode and B4iBuilder.

How make Xcode send to this device instead simulator WITHOUT use B4iBridge?

Can pass some parameter or change some in B4i to do that?

Thanks

Alberto Iglesias

 

[Erel]

Can pass some parameter or change some in B4i to do that?

No. Did you encounter any issue with B4i-Bridge?

 

[Alberto Iglesias]

Yes, always when I compile occurs a lot of errors independent of the app.

for reproduce right now, I create a new B4i project and when I compile, look:

I think this is trash in xcode, I don´t now. Occurs the same if press "Clean Project" even clean in xcode any project.

for work I need to try more than 20 times or more.....

by the way: I have installed b4ibuilder in two MACs and both to the same.

And I tried with iPhone, iPad.....

:-(

 

[Erel]

The code in the error doesn't match the B4i source code. Try to uninstall all debugging apps from the device and make sure you start the correct one.

 

[Alberto Iglesias]

Is a new iPhone, don´t have any apps, just this clean example and B4iBridge.

Can be some from Xcode? This app appears in log "EASAMPLE" it´s a xcode project I create. How can B4i see this?

If I create some xcode project directly in Xcode by cable, work perfectly, but when create with B4i connected by bridge, do this errors

 

[Erel]

Maybe Xcode is misconfigured. If you like I can send you a temporary user id for the hosted builder and you can try it.

 

[Alberto Iglesias]

misconfigured? what I need to configure? Have some tip I can do here? the Xcode is updated to 8.2.1

I can try with a temporary user in your host ( i very sure is gonna work), but I NEED our MAC go work with MacBuilder.

 

[Erel]

Are you 100% sure that the app created with Xcode was not installed on the device? B4i-Bridge starts the debugging app based on the url scheme. If you used the same one as the debugging app then it could have started the wrong one.

 

[Alberto Iglesias]

With the Host builder works very well, slower but works.

and about "B4i-Bridge starts the debugging app based on the url scheme".... this scheme is not based on Bundle ID is correct? So, when macbuilder send to iphone I this replace old one, right? or keep some cache data?


for now I try to delete this folders on Mac

/Library/Developer/Xcode/DerivedData
/Library/Developer/Xcode/Archives

and for now is working.

Another thing is in an iphone with anothers apps installed (created by b4i), when I started a new one project and run it, a lot of apps started together this one? Strange behavior.

 

[Erel]

this scheme is not based on Bundle ID is correct?

That's true. Also note that only applications compiled in debug mode are set with a url scheme. So if you make sure that there is only a single deployed debugged app then it will always work properly.

 

[Alberto Iglesias]

OK. I will check it out again.

Thanks for this information Erel.