B4R Question keep the code on the board

[omarruben]

Hello , I have tried a few samples and they work really well, now I want to keep the code on the Arduino board, so next time I connect the power , it runs the code.


I did it, but the code never runs, Am I doing some mistake?

 

[Erel]

The code is always saved on the Arduino board. There is nothing special that you need to do.

 

[Cableguy]

What board are you using?
Some boards require the programming state to be "defined" by hardware and then to run in normal mode, those hardware "definitions" need to be undone.
Arduino does it all that in an automatical way, but boards like ESP02 do require that as a complement

 

[tigrot]

What board are you using?
Some boards require the programming state to be "defined" by hardware and then to run in normal mode, those hardware "definitions" need to be undone.
Arduino does it all that in an automatical way, but boards like ESP02 do require that as a complement

They are a sort of jumper(s) or switches.

 

[Cableguy]

They are a sort of jumper(s) or switches.

Some boards require a resistor to either vcc or ground

 

[omarruben]

thanks for your answers,, I have Arduino Leonardo, and using jAWTRobot
https://b4x.com/android/forum/threads/jawtrobot-invoke-keyboard-and-mouse-events-etc.55832/

 

[Cableguy]

Arduino series board should not need those hardware tweaks... Once usb u'plugunpand re-powered, the program should run as coded. Can you post more about you program, like, main objective, schematics, etc?

 

[omarruben]

thanks again, #Erel and #Cableguy , I am using the same code from this link on the forum:
https://www.b4x.com/android/forum/threads/code-modules-keyboard-mouse-etc.77417/#content

I did power cycle , still does not run by it own, maybe something to do with the usb interface

 

[Cableguy]

I have read about Arduino clones going berserk. I have several clones, no issues up till today!