That's good, thank you.
Apparently, it is not necessary to set the baud rate, they even could be different for both channels.
What makes the difference to a terminal emulator that needs the baud rate to be set?
Experimenting I found out:
When you run a terminal emulator (Hterm) prior to the B4J application then the baud rates you have set in Hterm to individual com ports is known to the B4J apllication. I used com3 (9600 baud) and com4 (38400), and other rates. I was wondering why B4J did not need to set the baud rate. So, that was the solution - but who knows why.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.