I am currently porting a B4A app over to B4J and have found the 'Bal2Bjl' tool that has come in quite handy. There seems to be an oddity though when porting the bal to bjl, in that when I run the app and the code runs to re-position buttons at run time, the code doesn't seem to work. What I did then was to copy the ported bjl in the designer to a new duplicate screen, and when I run that duplicate screen it seems to then work (Generally).
I have however found another oddity on that when I open one of the screens, the button doesn't re-position upon load. If I close the form though and open the same screen again then the button does move into position. Does anyone have any ideas on what could be causing this behavior?
I have however found another oddity on that when I open one of the screens, the button doesn't re-position upon load. If I close the form though and open the same screen again then the button does move into position. Does anyone have any ideas on what could be causing this behavior?