B4J Question Raspberry PI cut off USB power

[wl]

Hi,

I'm looking into a way of programatically cut off power to some of the USB ports of a Raspberry PI 3. If found this thread: https://github.com/codazoda/hub-ctrl.c

Surely I can use a Jshell to call the hub-ctrl application, but is there any way to do it in B4J directly ?

Thanks !

 

[XorAndOr]

hi
look at https://www.b4x.com/android/forum/threads/libary-jkssh2-ssh2-communication-in-b4a.20048/
The lib is for b4A but it works in B4J (you need set your raspberry SSH, go into setup)

 

[wl]

hi
look at https://www.b4x.com/android/forum/threads/libary-jkssh2-ssh2-communication-in-b4a.20048/
The lib is for b4A but it works in B4J (you need set your raspberry SSH, go into setup)

Thanks but I'm not sure I understand what you mean. I want to write an application to run on the Raspberry Pi (using B4J) that can disable/enable power to the USB ports. I'm not sure where the SSH fits in this ...

Thanks