iOS Question [SOLVED] - Problem with B4i-Bridge

[JMB]

Hi there,

I have a problem getting my compiled project to run on the iPhone via Bridge.

My code compiles via the local host. I run B4i Bridge on the device, and the Designer shows up fine on the device.

When I try to connect to the IP address, it says "Trying to Connect to device. Make sure to start B4i Bridge."

Bit confused... (no change there then!)

JMB

 

[aeric]

Does "Clean Project (Ctrl+ P)" help?

 

[Erel]

What do you see on the device while the IDE tries to connect? It should ask you whether you allow the installation.

 

[JMB]

Does "Clean Project (Ctrl+ P)" help?

Clean Project made no difference.

All I see on the device is the B4i-bridge application - a blank white screen.

There is no request to allow the installation.

JMB

 

[Erel]

Have you tried it with the hosted builder?

 

[JMB]

I've managed to lose the working installation for B4i as I reconfigured the Profiles so that it would work with X-Code, as per another thread I started.

I shall have to figure out whether to go with B4i or Swift in X-code as it appears that doing both at the same time is not an option.

JMB

 

[JMB]

This has been solved by using the Hosted Server option, and completely separating out the compile and provisioning process for the two systems.

See https://www.b4x.com/android/forum/threads/solved-cant-use-x-code-and-b4i.103228/#post-647180

Thanks for your help, Erel

JMB