iOS Question [SOLVED] - Problem with B4i-Bridge

JMB

Active Member
Licensed User
Longtime User
Hi there,

I have a problem getting my compiled project to run on the iPhone via Bridge.

My code compiles via the local host. I run B4i Bridge on the device, and the Designer shows up fine on the device.

When I try to connect to the IP address, it says "Trying to Connect to device. Make sure to start B4i Bridge."

Bit confused... (no change there then!)

JMB
 

JMB

Active Member
Licensed User
Longtime User
Does "Clean Project (Ctrl+ P)" help?
Clean Project made no difference.

All I see on the device is the B4i-bridge application - a blank white screen.

There is no request to allow the installation.

JMB
 
Upvote 0

JMB

Active Member
Licensed User
Longtime User
I've managed to lose the working installation for B4i as I reconfigured the Profiles so that it would work with X-Code, as per another thread I started.

I shall have to figure out whether to go with B4i or Swift in X-code as it appears that doing both at the same time is not an option.

JMB
 
Upvote 0
Cookies are required to use this site. You must accept them to continue using the site. Learn more…