I am using B4A V3.50. I encountered that when I perform the debugging in rapid mode, the changes was not deployed/Updated correctly. This is happened when I switch from one module to another module in debug mode. The previous changes will be reversed. I am not sure is it due to my local computer configuration or it's a real bug. But the problem not in Release mode.
Below is the steps I performed to get the problem.
1. Run the program in debug(rapid) mode in multi-module apps.
2. Switch to another module and do some changes. Then save and test the module from the phone. The changes is take effect during this change.
3. Then switch to another module and do a changes or save the module. Then test this module from the phone. Then go back to the #2 module. The changes will be reversed back to before change.
Thank you.
Below is the steps I performed to get the problem.
1. Run the program in debug(rapid) mode in multi-module apps.
2. Switch to another module and do some changes. Then save and test the module from the phone. The changes is take effect during this change.
3. Then switch to another module and do a changes or save the module. Then test this module from the phone. Then go back to the #2 module. The changes will be reversed back to before change.
Thank you.
